Preparation

Gather materials in an area with an electrical outlet close by for the glue gun. An adult should handle steps 1-4 for young ones.

Let’s Do It

1. Prepare the Lid:
   Draw a circle on the lid using the hose connector as a size guide. Cut it out, erring on the side of caution to make it slightly smaller for a snug fit when inserting the connector.

2. Insert the Connector:
   Insert the connector into the lid.

3. Create a Hole for the Straw:
   Heat a nail or screwdriver and make a hole for the straw in the side of the bottle. The hole should be about ¾ of the height of the straw measured from the bottom of the bottle, and make it just big enough for the straw to fit snugly.

4. Secure the Straw:
   Use a glue gun to secure the straw in place.

5. Prepare the Balloon:
   Put a balloon on the end of the spray head and inflate it. Hold the spray head’s handle open while blowing and insert it into the connector on the lid.

6. Start Pouring:
   Add your beverage to the bottle, place the lid and balloon setup on the bottle, and your party pourer is ready!